Installation
Haldex controller for original 4Motion cars can be installer plug and play.
The inline wiring set is needed.
Remove connector from the Haldex unit and connect this side to the wiring loom with grey connector.
Connect the loom with black connector to the Haldex unit.
To run the Haldex Controller standalone you need the standalone wiring set.
Use table bellow to connect the wires from the grey wiring loom.
Connect both grey and black to the Haldex Controller and turn on the ignition.
Install the App thru the Google Play store search for Haldex Controller or go to:
https://play.google.com/store/apps/details?id=vanderveerengineering.haldexcontroller
On first start of the App it will search for Bluetooth devices.
Select the Haldex Controller this device will be saved and used on the next startup.
Connect with pincode 1234.
Grey - Car Connector Standalone and original:
| 1 | Red | 12v ignition | 10A Fuse |
| 2 | Brown | Ground | |
| 3 | Black/Red | Brake | 12v brake lights |
| 4 | Grey | K-Line | Only for Gen 1 |
| 5 | - | Output 1 | (Not used) |
| 6 | Orange/Brown | CAN-BUS Low | To car |
| 7 | Orange/Black | CAN-BUS High | To car |
| Extra for Standalone: | |||
| 8 | White | Output 2 | Can be used for RPM output for tacho |
| 9 | Brown/White | Handbrake | Ground signal |
| 10 | Blue/White | Speed VSS | 12v VSS Speed signal |
| 11 | Green | Throttle position | 5v Input |
| 12 | Yellow | Boost pressure | 5v Input |
Black - Haldex connector:
| 1 | Red | Power 12v ignition | |
| 2 | Brown | Ground | |
| 3 | Black/Red | Brake signal | |
| 4 | Grey | K-Line | Only for Gen 1 |
| 5 | - | (Not used) | |
| 6 | Orange/Brown | CAN-BUS Low | |
| 7 | Orange/Black | CAN-BUS High | |
| 8 | Brown/White | Sensor Ground | Manual Switch Gnd (Option) |
| 9 | Brown/White | Handbrake | Ground signal (Only for Gen 1) |
| 10 | - | Input 1 | (Not used) |
| 11 | Grey/Red | 5v Supply | Manual Switch 5v (Option) |
| 12 | White | Manual Switch | Manual Switch Signal (Option) |
Small 3 pin connector – Manual Switch
| 1 | Orange | Manual Switch | Manual Switch Signal |
| 2 | Red | 5v Supply | Manual Switch 5v |
| 3 | Brown | Sensor Ground | Manual Switch Ground |
CANBUS Communication
Jumper JP1 CAN-BUS Line termination can be changes inside the controller.
Left jumper for car side
Car with can-bus system already have termination so the jumper must be open.
For cars with only the ECU the jumper must be closed
Right jumper for Haldex side
Needs to be closed
