0
Your shopping cart is empty!


Haldex wiring loom OEM installation

Rate this item
(0 votes)
Written by Thursday, 04 April 2019 19:09;
Published in Blank;

haldex wiring loom oem complete incl fuel sender

 

Wiring installation

2 PIN Sensor From  To            
LI/BR T2/2 T36/16 Plug in Signal   Blue/White Sensor Signal plug it into cluster connector T36 pin 16
BR/BL T2/1 T36/33 Solder Sensor ground Brown/White Ground signal solder to wire from cluster connector T36 pin 33
                 
3 PIIN Sensor                
BR/BL T3/1 T32/20 Solder Sensor ground   Brown/White   Ground signal solder to wire from cluster connector T32 pin 20
BL T3/2 T32/3 Plug in Signal   Blue   Sensor Signal plug it into cluster connector T32 pin 3
LI/WI T3/3 T32/4 Plug in Signal       Sensor Signal plug it into cluster connector T32 pin 4
                 
 Haldex Connector                
SW/LI T8/1   Solder 12v   Red   Connect to switched 12volt you can find one behind fusebox driver side
BR T8/2     Ground   Brown   Connect to ground
OR/BR T8/5   Solder CAN Low   Orange/Brown Connect to canbus wires near the gateway located above footwell the pedal right side 
OR/BL T8/6   Solder CAN High   Orange/Black Connect to canbus wires near the gateway located above footwell the pedal right side 
SW/RO T8/3 E/2 Solder Brake   Black/Red Connect to black/red wire on connect E pin 2 from the electronic module under steeringwheel
                 
T2 Fuel sender connector 2 Pin          
T3 Fuel sender connector 3 Pin            
T8 Haldex Connector 8 Pin            
T32 Cluster connector Blue 2008+            
T36 Cluster connector Black before 2008    
E Connector E on Central module above footwell driver side    

haldex wiring loom oemhaldex wiring loom oem connect side

Read 462 times Last modified on Wednesday, 29 May 2019 20:43
Login to post comments