Default mode

The controller will start in the selected mode, in last used mode the controller starts in de mode that was used the last time.

Manual Switch

When the Haldex Controller is delivered with a manual switch this option must be activated to use the switch.
Only activate when a switch is connected or it could leed to unwanted behavior!

Return mode

When the manual switch is set to App mode it will go to the selected mode.

Brake Ignore

By default the Haldex is turned off when brake pedal is applied.
Turn this option ON and the Controller will ignore the brake signal and keep the Haldex on the selected value.

Button on main screen

As requested for use on track to easly switch the brake ignore option from the main screen.
Turn ON will add a button on the main screen to toggle brake ignore option.

Brake Image

By default the brake icon is gray and light gray.
Turn on will set the brake active icon on the main screen to red.

 

Main Screen

Normal is the default layout.
Race layout has been added to be used in landscape mode and will have big buttons.

 

Haldex Broadcast

Special option only used in special occasions, only needed in inline configurations with cars that do not accept the haldex on the CAN network.
Turn off will block haldex traffic to the car this will fix ABS coding problem where coding of 4motion is not possible.

 

Haldex Values

Extended Haldex value range, normal range is in steps of 10%.
When enabled a wider range will be available.

(Currently only for Gen2, Gen5 0CQ more will follow)

Gen5 0CQ Mode

OEM Mode
Standalone Mode

Gen5 Traction mode

Standard
Increased tracion
Reduced noise

Language

The app uses the phone's language and applies app translation if available.
To overwrite you can select a available language.

Controller Firmware

This is the main controller firmware version.

COM Module Firmware

This is the Communicatioin module firmware version.

Serial Number

Serial number of the controller

Platform

Main platform the controller is programmed for.
VAG, Volvo, Saab.

Haldex Type

The Haldex module the controller is programmed for.
On request this can be changed with the app.

BT Address

Bluetooth module MAC Address

Controller temperature

Controller main chip temperature

Boost calibration

This option allow calibration for the analog boost sensor input.
Check datasheet from used pressure sensor for correct values.
VAG Boost sensor will mostly have 555 mBar per 1 volt.

Throttle calibration

Throttle calibration for the analog input, here you can set the low and high point off the throttle pedal.

To calibrate, have the pedal in upper position and do not touch the pedal. click on the Throttle low Set button and the position is saved.
Fully press down the pedal and press the Throttle high set button and the position is saved.
Check if the throttle value in between 0% and 100%.

Controller Reset

When the button is pressed all current settings will be restored to the default factory setting.

Controller Reboot

When the button is pressed the Controller will reboot.